KOPRIWA CONTROLLERS & PRO CONTROLLERS
31.03.2008 10:49
A CONTROLLER WITH SERIOUS ATTITUDE!
A JOINT PROJECT FROM Fritz Kopriwa (of Telechoke fame) & Jiri Micek (manufacturer of the Pro 3 hand controller.)
The TELECHOKE 2 CONTROLLER
This Controller features all the requirements that these two experienced racers could think of!
This integrated unit features almost everything you could want from a controller (although it runs so cool it definitely won’t make toast!)
THE HANDLE
The conventional Pro 3 adjustments for “Chip” have now been extended and feature 9 chips of the following values, 140, 127.5, 97.5, 82.5, 67.5, 60, 50, 40 &32.5 ohms.
Brakes feature a 12 step rotary switch adjustment.
Sensitivity is adjusted by a 12 step rotary switch.
Voltage control is by 4 step rotary switch giving 0, 1, 1.6 or 2.8 volts of reduction.
Choke control is by a 12 step switch giving 0, 1,2,3,4,6,8,10.12.14.16.18 feet of choke.
The controller features a new wiper assembly and also a gold plated wiper band.
THE BOX
The electronics are housed in a Kopriwa Telechoke housing with monster heat sink, twin fan cooling, twin transistors, relay operated wire chokes and voltage control circuits, Auto off restable overload and LED displays which show track voltage,, choke and blast relay settings.
Assembled in Switzerland to the highest standards, this controller will run ANY slot car on the Planet! These controllers are built to special order only. (delivery approx. 2 months).
£525.00
The controller also features 2 options for blast relay operation
REDUCTION will allow the voltage reduction to be enabled or disabled at full power.
The MASTER will allow the chokes to be enabled or disabled at full power.
Illuminated display gives readouts for track power and choke setting, flashing led’s indicate blast relay status.
———
Indietro












